Why does my Huntleigh SC300 Monitor show 'NIBP time-out'?
If the Huntleigh Monitor displays 'NIBP time-out', it means that the measurement time has exceeded 120s in adult/child mode or 90s in neonate mode. Check the patient type setting and connection. If needed, replace the cuff. If the error continues, contact service personnel.
What does 'NIBP signal saturated' mean on Huntleigh Monitor?
If the Huntleigh Monitor displays 'NIBP signal saturated', it indicates excess motion. Reduce the motion and measure again.
What causes 'Too much light' error on Huntleigh SC300 Monitor?
If the Huntleigh Monitor displays 'Too much light', the SpO2 sensor is too loose. Reposition the SpO2 sensor.
How to resolve 'NIBP excessive motion' error on Huntleigh SC300?
If your Huntleigh Monitor displays 'NIBP excessive motion', it means there is arm motion. Check the patient’s condition and reduce the motion.
What to do if Huntleigh Monitor shows 'Air leak'?
If the Huntleigh Monitor indicates 'Air leak', it means the NIBP cuff isn't properly connected, or there's a leak in the airway. Check the connection, and if needed, use a new cuff. If the problem continues, contact service personnel.
How to fix 'Loose cuff' error on Huntleigh Monitor?
If the Huntleigh Monitor displays 'Loose cuff', it indicates that the NIBP cuff is not properly connected. To resolve this, check the cuff and connect it again properly.
What to do if Huntleigh SC300 Monitor displays 'Weak signal'?
If your Huntleigh Monitor shows 'Weak signal', check the patient’s vital signs and consider changing the measurement site.
General| Type | Fetal Monitor |
|---|---|
| Model | SC300 |
| Manufacturer | Huntleigh |
| Display | LCD |
| Paper Speed | 1, 2, 3 cm/min |
| Parameters Monitored | Fetal Heart Rate, Uterine Contractions |
| Frequency Range/Ultrasound Frequency | 1 MHz |
| FHR1 Range | 30 – 240 bpm |
| FHR2 Range | 30 – 240 bpm |
| UC Range | 0 to 100 mmHg |
| TOCO Range | 0 to 100 mmHg |
Provides critical safety warnings and cautions for operating the monitor.
Identifies and explains the function of front panel controls and symbols.
Details the controls and connectors located on the rear panel of the monitor.
Identifies controls and optional components on the side panels.
Explains the meaning of various symbols and indicators used on the monitor.
Details the functions of the monitor's operational keys and buttons.
Explains how to connect the AC power cord to the monitor and a power outlet.
Details how to connect NIBP hoses, cuffs, and SpO2 sensors to the monitor.
Explains the power-on self-test process and what to verify.
Describes how to initiate and terminate NIBP measurements.
Explains how to configure and use automatic NIBP measurement intervals.
Guides on how to establish a wireless connection between the thermometer and monitor.
Details the procedure for taking a temperature measurement.
Introduces troubleshooting by explaining error codes and fault presentation.
Lists common errors and provides suggestions for correction.
Guides users on how to contact technical support and obtain service manuals.
To Next Page