Husqvarna 120 - Assembling the Ignition Module and Flywheel

English - 31
Repair Instructions
7.6 Assembling the ignition module and
flywheel
1
Place the ignition module in position and fit the
screws. See figure 13. Do not tighten the screws.
Fig 14
2
Fit the flywheel onto the crankshaft pin. Turn the
flywheel until the key fits into the key slot on the
shaft. See figure 14.Tighten the nut for the fly-
wheel.
3
Insert the plastic air gap tool (a), at a thickness of
0,3 +- 0,1 mm, between the lugs on the ignition
module and flywheel. See figure 15.
Turn the flywheel so that the magnets are posi-
tioned opposite the ignition module. Tighten the
screws, at a tightening torque of 2 - 3.5 Nm. Re-
move the plastic air gap tool.
4
Attach the ignition cable to the ignition module.
5
Then fit the:
• air guide plate and press the cable in place.
• starter, at a tightening torque of 2 - 3.5 Nm.
• cylinder cover and air filter cover.
Fig 15
Fig 13