46 - English
1
When replacing the fuel filter, the old fuel filter must
be taken out of the tank unit using special tool
502 50 83-01.
2
Pull out the fuel hose from the tank unit and pull
away the filter A. See figure 52.
3
Fit the new fuel filter and insert the fuel hose back
into the fuel tank.
7.17 Replacing the primer bulb
Dismantle
1.
Dismantle the cylinder cover.
2.
Make the primer bulb comes loose by pressing
on the bulb holder with a flat-ended screwdriver,
outlined in figure 53..
3
Pull out the primer bulb and loosen the return and
suction hose.
Fig 52
Fig 53
NOTE!
Fluted pliers may not be used with the fuel
hose. They can cause material damage
resulting in damage to the fuel hose.
Repair Instructions
7.16 Replacing the fuel filter
7.15 Vibration damping system
Dismantling
Remove the spring dampers on both sides. See
figures 51.
Cleaning and inspection
• Clean and inspect all parts carefully. If there
are any cracks or other defects, replace the
damaged parts with new ones. Always use
original parts.
Assembly
Fit the spring dampers on both sides. See figures
51. Tightening torque 2 - 3 Nm
Fig 51
To Next Page
Loading...
