32 - English
Repair Instructions
4
Dismantle the clutch according to figure 18. Care-
fully remove the clutch spring.
Fig 18
NOTE!
Be careful with the clutch spring;
opening them too much can result in
material damage.
Cleaning and inspection
• Clean and check all parts carefully. Parts must
be replaced if cracked or showing signs of
other defects. Always use original spare parts.
• Check the thickness of the clutch shoes by meas-
uring them with slide callipers across the whole
clutch hub. If the thickness is below 60 mm, the
clutch must be replaced. See figure 19.
Min 60 mm
Fig 19
2
Remove the spark plug hat and the spark plug. In-
sert the piston stop (575 29 36-01). See figure 17.
3
Use a heat gun on the clutch to loosen the thread
lock before loosening the clutch using tool 513 63
60-01 and a suitable socket wrench. Knock the
tool gently in position. Turn the clutch clockwise to
loosen it. See figure 17.
Fig 17
7.7 Dismantling the centrifugal clutch
1
Remove the cylinder cover. Release the brake by
moving the front hand guard backwards. Loosen
the bar nuts and remove the clutch cover, saw
chain and guide bar. See figure 16.
Fig 16
To Next Page
Loading...
