24 - English
Safety equipment
6.8 Resistance test - stop switch
1
Dismantle the stop switch as outlined in “6.6 Dis-
mantling the stop switch”.
2
Clean the contact areas.
3
Test the resistance by connecting a multimeter
to the stop switch. See figure 16. The resistance
should be as follows:
”0” pressed in - less than 0.1 Ω.
”1” pressed in - more than 1000 Ω.
Fig 16
6.9 Dismantling the throttle lockout,
throttle control and spring
1
Loosen the four screws on the rear handle. Re-
move the handle cover. See figure 17.
Fig 17
2
Release the throttle wire with a plier.
3
The throttle control and the throttle lockout are now
easily detached. Notice the position of the spring,
see the call- out of figure 18.
Fig 18
To Next Page
Loading...
