Husqvarna 125 - Dismantling the Piston and Cylinder

English - 47
Repair Instructions
7.19 Dismantling the piston and cylinder
1
Dismantle the:
• cylinder cover
• carburettor
• muffler
• spark plug cap
• intake system
2
Remove the cylinder’s four screws.
Carefully lift away the cylinder and the gasket.
See figure 56.
Fig 56
x4
3
Cover the crankcase opening, see figure 57
Fig 57
NOTE!
Take care to prevent any dirt and foreign
particles from entering the crankcase.
Assembling
1. Fit the return and suction hose on the primer
bulb.
2. Snap the primer bulb in place.
3. Fit the cylinder cover.
7.18 Replacing the fuel hose/return hose
The fuel hose is moulded and can only be removed
from outside of the fuel tank.
Use suitable pliers with a smooth cutting face and
loosen the fuel hose from the fuel tank. See figure
54.
Replace the return hose when required. Tighten
the fuel hose on the filter side with your fingers.
Fig 54