34 - English
Cleaning and inspection
• Clean and check all parts carefully. Parts must
be replaced if cracked or showing signs of
other defects. Always use original spare parts.
Repair Instructions
7.10 Assembling the oil pump and screen
1
Replace the oil pump, connect oil hoses to the pump
and put the pump back in place, tighten the screws.
2
Fit the pump drive wheel and apply thread lock to
the screws. Tightening torque 3 - 4 Nm. See figure
22B.
3
Fit the clutch. See the “Assembling the centrifugal
clutch” chapter.
4
Fit the saw chain, guide bar and clutch cover.
WARNING!
Insufficient saw chain lubrica-
tion can result in chain breakage,
which can cause serious personal
injury.
7.11 Dismantling the intake system
1
Remove the cylinder cover and the air filter.
2
Loosen the three screws shown in figure 23, and
remove the air filter system.
3
Remove the choke and the throttle wire.
4
Detach the fuel hose.
5
Lift the carburettor up, detach the hose under the
carburettor and remove the carburettor.
6
Loosen the 2 screws for the intake flange, C. See
fig 24.
7
Dismantle the intake flange, A. See figure 24.
8
Dismantle the inlet pipe assy, B See figure 24.
Fig 23
Fig 24
A
B
Fig 22B
L
O
C
T
To Next Page
Loading...
