Husqvarna 125 - Tank Unit

English - 45
Repair Instructions
Assembly
1.
Fit the tank unit. See figure 50.
2.
Fit the earth cables.
3.
Fit the stop control cable from the ignition module.
4.
Fit the two hoses and the throttle wire. See figure
49.
5.
Fit the starter, cylinder cover, clutch cover, saw
chain and the guide bar.
7.14 Tank unit
Dismantling
1.
Drain the fuel from the tank.
2.
Remove the clutch cover, saw chain, guide bar,
starter and the cylinder cover. Remove the rear
handle cover.
3.
Detach the two hoses and the throttle wire, marked
in figure 49.
4.
Remove the handle bar and the chain catcher.
5.
Detach the cabling from the stop switch and earth-
cabling from the crankcase.
6.
Loosen the screws outlined in figure 50 and
remove the tank unit..
Fig 49
Fig 50
WARNING!
The fuel used in the chain saw has
the following hazardous properties:
1. The fluid and its vapour are poisonous.
2. Can cause skin irritation.
3. Is highly inflammable.