3. Pull the choke control out to set the choke control in
choke position.
4. Push the decompression valve (A).
5. Continue to
To start the product on page 13
for
more instructions.
To prepare to start with a warm engine
WARNING: The chain brake must be
engaged when the product is started to
decrease the risk of injury.
1. Move the front hand guard forward to engage the
chain brake.
2. Set the start/stop switch to on.
3. Push the decompression valve.
4. Continue to
To start the product on page 13
for
more instructions.
To start the product
WARNING: You must keep your feet in
a stable position when you start the product.
WARNING: If the saw chain rotates at
idle speed, speak to your servicing dealer
and do not use the product.
1. Put the product on the ground.
2. Put your left hand on the front handle.
3. Put your right foot into the footgrip on the rear
handle.
4. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING: Do not twist the starter
rope around your hand.
5. Pull the starter rope handle quickly and with force.
CAUTION: Do not pull the starter
rope to full extension and do not let go of
the starter rope handle. This can cause
damage to the product.
a) If you start your product with a cold engine, pull
the starter rope handle until the engine fires.
Note:
You can identify when the engine fires
through a "puff" sound.
b) Disengage the choke.
6. Pull the starter rope handle until the engine starts.
964 - 003 - 20.02.2021
13
To Next Page
Loading...
