Why is the light flashing blue on my Husqvarna Lawn Mower?
A blue flashing light indicates that the boundary loop is not connected to the charging station. Ensure that the boundary wire connectors are properly fitted to the charging station.
Why does my Husqvarna Lawn Mower say 'No loop signal'?
This can occur when ECO mode is active and the mower tries to start outside the charging station. Place the Husqvarna Lawn Mower in the charging station, initiate the start sequence, and then close the hatch. It may also happen if the pairing between the mower and the charging station is lost. In this case, place the mower in the charging station and generate a new loop signal.
Why is the Husqvarna Lawn Mower showing a blue flashing light?
If the Husqvarna Lawn Mower displays a blue flashing light, it typically indicates a problem with the boundary loop connection or a break in the loop. First, ensure the boundary wire connectors are correctly attached to the charging station. If the problem persists, there may be a break in the boundary loop. Locate the break, replace the damaged wire section with a new one, and securely splice it using an original coupler.
What to do if my Husqvarna 310 Lawn Mower displays a solid red light?
If your Husqvarna Lawn Mower shows a solid red light, this indicates a fault within the charging station's circuit board or an incorrect power supply. In this case, you should contact your local Husqvarna representative for assistance.
Why is my Husqvarna 310 showing a red flashing light?
If the Husqvarna Lawn Mower is displaying a red flashing light, it means there's an interruption in the charging station's antenna. Contact your local Husqvarna representative for assistance.
Why does my Husqvarna Lawn Mower go outside the working area?
If your Husqvarna Lawn Mower is operating outside the designated working area, several factors could be at play. First, verify that the boundary wire is correctly connected to the charging station. Incorrect connections can lead to this issue. Also, ensure the boundary wire isn't too close to the work area's edge, as it should be laid according to the provided instructions. Metal objects or buried cables near the boundary wire can also cause disturbances; try relocating the wire. Finally, if there are multiple installations nearby, try generating a new loop signal while the product is in the charging station.
What to do if my Husqvarna 310 Lawn Mower is trapped?
If your Husqvarna Lawn Mower gets trapped, it might be stuck in a confined area with multiple obstacles. Inspect the area for obstructions hindering movement. Remove these obstacles or create an island around them to allow the mower to navigate freely.
Why does my Husqvarna Lawn Mower have no loop signal?
If your Husqvarna Lawn Mower displays 'No loop signal', it could be due to several reasons. The boundary wire might be broken, or the power supply isn't connected. Also, the connection between the mower and charging station may be broken. The boundary wire could be laid incorrectly around an island, or there might be disturbances from metal objects or buried cables. The power voltage cable could be damaged or not connected, or the boundary wire isn't connected to the charging station. If ECO mode is on, place the mower in the charging station, press START, and close the hatch. Check the LED on the charging station to troubleshoot the loop signal.
Why is my Husqvarna 310 Lawn Mower charging station showing a red flashing light?
A red flashing light on your Husqvarna Lawn Mower charging station indicates an interruption in the charging station’s antenna. Unfortunately, I cannot provide specific troubleshooting steps for this issue. Please contact your local Husqvarna representative for assistance.
Why does my Husqvarna 310 Lawn Mower have a battery problem?
If your Husqvarna Lawn Mower displays 'Battery problem', it could be due to several reasons. The battery might not be connected properly, so dismantle the mower and check the battery connection. The battery might be faulty, so check the connection again. Ensure you are using only original batteries from Husqvarna. The main circuit board could also be faulty.
General| Type | Robotic lawn mower |
|---|---|
| Sound level Measured | 58 dB(A) |
| Typical charging time | 60 minutes |
| Cutting system | 3 pivoting blades |
| Battery type | Lithium-ion |
To Next Page
