Why does my Husqvarna 310 Lawn Mower have no drive?
If your Husqvarna Lawn Mower has 'No drive', it might be caught in something. Free the mower and fix the cause. If it is due to wet grass, wait until the lawn dries. The working area might have a steep slope; isolate slopes steeper than 40%. If the guide wire is on a slope, ensure it's laid at an angle across the slope.
Why does my Husqvarna Lawn Mower need manual charging?
If your Husqvarna Lawn Mower displays 'Needs manual charging', the mower is set to the Secondary area operating mode. Place the mower in the charging station; this is normal and requires no further action.
How to fix 'No loop signal' on a Husqvarna 310?
The 'No loop signal' message on your Husqvarna Lawn Mower can appear if the boundary wire is crossed on its way to and from an island. Check that the boundary wire is laid according to instructions, ensuring it's in the correct direction around any islands. Also, disturbances from metal objects (fences, reinforcement steel) or buried cables nearby can cause this issue. Try moving the boundary wire or creating islands in the work area to boost the signal strength. Another possibility is that the mower is too far from the boundary wire. Redo the boundary wire installation to ensure all parts of the work area are a maximum of 35 m / 115 ft from the boundary wire.
What to do if the cutting system of my Husqvarna 310 Lawn Mower is blocked?
If the cutting system of your Husqvarna Lawn Mower is blocked, there are a few possible reasons. It could be that grass or another object has become wrapped around the blade disc; in this case, check the blade disc and remove any obstructions. Another possibility is that the blade disc is sitting in a pool of water; if so, move the product and try to prevent water from collecting in the work area. Finally, the grass may be too high. Cut the grass before installing the product, ensuring it's no more than 10 cm / 3.9 in.
How to fix a blocked wheel motor on my Husqvarna 310 Lawn Mower?
If the wheel motor of your Husqvarna Lawn Mower is blocked, it's likely due to grass or another object wrapped around the drive wheel. To resolve this, check the drive wheel and carefully remove any obstructions.
What to do if the Husqvarna 310 Lawn Mower has a blue flashing light?
If your Husqvarna Lawn Mower is showing a blue flashing light, it could be due to a couple of reasons. First, the boundary loop might not be properly connected to the charging station. Make sure the boundary wire connectors are correctly fitted. Alternatively, there might be a break in the boundary loop. If so, locate the break, replace the damaged section with a new loop wire, and splice it using an original coupler.
How to fix a break in the boundary loop of my Husqvarna Lawn Mower?
To fix a break in the boundary loop, find where the break is located. Replace the damaged section of the loop with a new loop wire, and splice it using an original coupler.
What to do if Husqvarna 310 Lawn Mower goes outside working area?
If your Husqvarna Lawn Mower is 'Outside working area', it can be due to crossed boundary wire connections at the charging station. The boundary wire might be too close to the edge or laid incorrectly around an island. The working area may slope too much at the boundary wire. If there are disturbances from magnetic objects or the mower has hard time distinguishing the signal from an installation close by, try moving the boundary wire and creating additional islands or generate a new loop signal.
What to do if Husqvarna Lawn Mower cutting system is blocked?
If your Husqvarna Lawn Mower says 'Cutting system blocked', grass or another object may be wrapped around the blade disc. Check the blade disc and remove any object. The blade disc might be in a pool of water, so move the mower and fix the water collection issue. The blade motor could be defective, so ensure it has the right speed. The main circuit board might be defective, so change it. The cabling to the blade motor could be damaged or faulty, so check and repair or replace the blade motor.
How to get Husqvarna Lawn Mower unstuck when it is trapped?
If your Husqvarna Lawn Mower is 'Trapped', it means the mower has got caught in something. Free the mower and fix the reason it became trapped. The mower might be stuck behind obstacles, so check for anything making it hard to move. Also, check that the body is properly secured in the front and rear rubber dampers, as one of the body’s attachments may have come loose.
General| Type | Robotic lawn mower |
|---|---|
| Sound level Measured | 58 dB(A) |
| Typical charging time | 60 minutes |
| Cutting system | 3 pivoting blades |
| Battery type | Lithium-ion |
To Next Page
