What to do if Husqvarna Chainsaw motor makes sudden movement, then stops?
If the electrical motor of your Husqvarna Chainsaw makes a sudden movement when you push the power trigger and then stops, it is likely due to a short circuit in the control unit. Replace the control unit.
What to do if Husqvarna Chainsaw shows red light after installing a new control unit?
If your Husqvarna Chainsaw shows a red light after installing a new control unit, it may be because the spare part comes without software. Use a diagnostic tool to install the software.
What to do if Husqvarna 330i charger does not start?
If the Husqvarna Chainsaw charger doesn't start and no LEDs light up when the battery is attached, check the following: ensure the connection between the charger and battery is clean and undamaged. Also, check the battery. If the issue persists, the charger itself may be defective. Disconnect the charger from the mains outlet for at least 1 minute, then reconnect it. Verify that the fan starts and a green LED illuminates for about 3 seconds. If not, replace the charger.
What to do if a warning sign flashes red on the battery of Husqvarna 330i Chainsaw?
If a warning sign flashes red on the Husqvarna Chainsaw battery when you press the start button, it could be due to several reasons: the battery temperature might be too high (wait until it cools down, or insert it into the charger to cool it faster), the voltage might be too low (charge the battery), the temperature could be too low (ensure the battery temperature is above -10° C), or the battery itself might be defective (replace it).
Why Husqvarna 330i won't start and no LEDs are on?
If your Husqvarna Chainsaw doesn't start and no LEDs light up when you press the power button, there could be several reasons. First, the battery might be defective; press the on/off button to check the battery – at least one green LED should illuminate. Other potential causes include a defective connection between the battery and the product (ensure the connectors are clean and undamaged), a faulty connection in the keypad connector (make sure it's correctly assembled, dry, undamaged, and free from corrosion), a broken keypad (replace it), damaged cables between the control unit and keypad/main switch (repair or replace them if damaged), or a short circuit in the control unit (replace it).
What to do if the red error LED comes on on my Husqvarna 330i?
The red error LED indicates that the cell difference is too much (1V). Speak to your servicing dealer.
Why is the warning indicator flashing on my Husqvarna 330i Chainsaw?
The warning indicator flashes because of a temperature deviation. To resolve this, ensure the battery is used in surroundings where temperatures are between 5°C/41°F and 40°C/104°F.
To Next Page
General
