3. Lift up the front body suspension parts by using a
small flat screwdriver. Pull the screwdriver gently
backwards.
4. Put the screwdriver between the suspension system
and the lower chassis. Push the screwdriver
upwards and remove the front body suspension part.
5. To assemble the front body suspension parts, refit
the pin into the slot and refit the ring into the correct
position.
6. Push the front body suspension part into the hole in
the lower chassis.
6.9 To replace the keypad
1. Remove the top cover. Refer to
To remove and
install the top cover on page 18
.
2. Remove the body. Refer to
To remove and install
the body on page 18
.
3. Remove the upper chassis. Refer to
To remove and
install the upper chassis on page 19
.
4. Disconnect all cables from the HMI circuit board.
5. Push the 2 clips to release the HMI circuit board.
Refer to
To replace the HMI circuit board on page
24
.
6. Peel off the keypad from the display cover.
7. Remove the keypad and thread the cable out
through the hole.
8. Clean the chassis from glue residue.
9. Remove the protective liner from the new keypad
and press the keypad into position.
CAUTION: There must not be any loose
corners or air bubbles as this can cause dirt
and moisture to get in under the keypad.
10. Install in opposite sequence.
6.10 To clean and replace the ventilation filter
Note: The ventilation filter needs to be cleaned regularly
and must be replaced if damaged.
1. Remove the top cover. Refer to
To remove and
install the top cover on page 18
.
2. Remove the body. Refer to
To remove and install
the body on page 18
.
3. Remove the 2 screws for the support.
1414 - 001 - Repair instructions- 21
To Next Page
Loading...
