What causes charging system problem in Husqvarna Automower 405X?
A charging system problem in your Husqvarna Lawn Mower can be caused by using an incorrect type of battery. Make sure to use original batteries recommended by the manufacturer.
Why are mowing and charging times shorter than usual on my Husqvarna Automower 405X?
If the mowing and charging times are shorter than usual on your Husqvarna Lawn Mower, the battery may be at the end of its life cycle and needs to be replaced.
What to do if Husqvarna Lawn Mower is stuck in charging station?
If your Husqvarna Lawn Mower is stuck in the charging station, there may be an object preventing it from leaving. Remove the object to allow it to exit.
Why does my Husqvarna Automower 405X need manual charging?
If your Husqvarna Lawn Mower needs manual charging, it is probably because the product is set to the Secondary area operating mode. Put the product in the charging station.
What to do if I forgot my Husqvarna Automower 405X PIN code?
If you've entered the wrong PIN code on your Husqvarna Lawn Mower, remember that only five attempts are allowed before the keypad is blocked for a period. Enter the correct PIN code. Contact Husqvarna customer service if you forget the PIN code.
Why does my Husqvarna Automower 405X say mower lifted?
If your Husqvarna Lawn Mower displays 'Mower lifted', it means the lift sensor has been activated. This can happen if the product gets stuck, so free the product and rectify the reason. Also, check the magnet and the lift sensor.
What to do if the Husqvarna Automower 405X Lawn Mower has a blue flashing light?
If your Husqvarna Lawn Mower is showing a blue flashing light, it could be due to a couple of reasons. First, the boundary loop might not be properly connected to the charging station. Make sure the boundary wire connectors are correctly fitted. Alternatively, there might be a break in the boundary loop. If so, locate the break, replace the damaged section with a new loop wire, and splice it using an original coupler.
Why is my Husqvarna Automower 405X charging station showing a red flashing light?
A red flashing light on your Husqvarna Lawn Mower charging station indicates an interruption in the charging station’s antenna. Unfortunately, I cannot provide specific troubleshooting steps for this issue. Please contact your local Husqvarna representative for assistance.
What to do if my Husqvarna Automower 405X Lawn Mower battery is empty?
If your Husqvarna Lawn Mower battery is empty, consider these possible causes. The mower might be unable to locate the charging station, so try changing the position of the guide wire. The battery could be at the end of its life cycle, requiring a replacement. Check if the charging station’s indicator lamp flashes red, which could indicate a defective antenna. Also, inspect the charging plates on the mower and the contact plates on the charging station for corrosion; if present, clean them using fine-grade emery cloth.
Why does my Husqvarna Lawn Mower have a low battery?
If your Husqvarna Lawn Mower is experiencing low battery issues, it could be due to a few reasons. The product may not be able to find the charging station, so try adjusting the position of the guide wire. Alternatively, the battery might be nearing the end of its life cycle and require replacement. Check the charging station for a defective antenna by looking for a flashing red indicator lamp. Lastly, corrosion on the charging plates of the product or the contact plates on the charging station can cause this; clean them with fine grade emery cloth.
General| Product Name | Husqvarna Automower 405X |
|---|---|
| Category | Lawn Mower |
| Cutting Width | 22 cm |
| Cutting Height, min-max | 20-50 mm |
| Battery Type | Li-Ion |
| Typical Charging Time | 60 min |
| Sound Level | 62 dB(A) |
| Working Area Capacity | 600 m² |
| Maximum Slope Performance Inside Installation | 40% |
| Maximum Slope Performance at Boundary | 15% |
| GPS-assisted Navigation | Yes |
| Automower Connect | Yes |
| Battery Voltage | 18 V |
| Connectivity | Bluetooth, Cellular |
| Weather Resistance | Yes |
| Smartphone App | Yes |
| Blade Type | Pivoting razor blades |
Illustrates and lists all components of the Husqvarna Automower product.
Explains the meaning of WARNING, CAUTION, and NOTE in the manual.
Provides essential safety instructions for operating the Automower.
Covers safety guidelines specific to installing the charging station and power supply.
Details safety measures to follow during the operation of the Automower.
Outlines safety instructions to be followed before performing maintenance.
Highlights critical safety information regarding the handling of lithium-ion batteries.
Details where to place the boundary wire, considering obstacles and slopes.
Detailed steps for installing the charging station, including safety precautions.
Step-by-step guide for installing the boundary wire and connecting it.
Instructions for installing the guide wire and connecting it.
Steps for setting up basic functions like language, country, and PIN.
Introduces the app's features for controlling and monitoring the Automower.
Instructions to pair the Automower Connect app with the product via Bluetooth.
Details the AIM technology for creating virtual lawn maps and zones.
Information about setting up the product's mowing schedule.
Step-by-step guide to set the daily or weekly mowing schedule.
How to set and adjust the cutting height for optimal grass cutting.
Guide to selecting and setting the desired security level for the product.
Instructions for changing the product's PIN code for security.
Steps to enable and configure the weather timer function.
Details GPS assisted navigation and specialized mowing modes.
Guide to enabling GPS assisted navigation for optimal operation.
How to set up lawn coverage for specific work areas and zones.
How to activate the virtual fence feature for theft protection.
Step-by-step instructions for starting the product and selecting operating modes.
Instructions on how to charge the product's battery correctly.
Detailed steps for cleaning the chassis and blade disc.
Importance of using genuine blades and safety precautions for replacement.
Step-by-step guide on how to replace the product's blades.
Information on battery charging, lifespan, and replacement.
Guide to resolving product faults and symptoms.
Lists product fault messages, their causes, and recommended actions.
Lists common product symptoms and their potential causes.
Lists information and warning messages, their causes, and actions.
Explains the meaning of the charging station's indicator lamp colors and patterns.
Provides a table of symptoms and their causes for troubleshooting.
Guide on how to locate breaks in the boundary or guide loop wire.
Detailed technical data for the 405X and 415X models.
Details the warranty coverage, duration, and conditions for the product.
To Next Page
