Husqvarna AUTOMOWER 430X Gluing Instructions

HUSQVARNA
AUTOMOWER® 330X / 430X
GLUING INSTRUCTIONS
Congratulations - having received this package your‘re just one step away from having your
very own customized Husqvarna Automower®. The illustration shows the single foil parts with
their corresponding names. For a satisfying result, please follow the instructions below.
1. Please clean your Automower at first. Use a damp, soft sponge or cloth to clean the body. If the
body is very dirty it may be necessary to use a soap solution or washing-up liquid.
2. Place the foil on an even surface. Pull the carrier paper at the side or at a corner for
2-3 centimeters away.
3. One after another, place the single foil parts at the corresponding areas (see pictures with the
numbers). Start with the released corner to fix the piece.
4. Slowly remove the rest of the carrier paper and carefully put the entire piece on the Automo-
wer®. Use the enclosed scratcher to get rid of caught air. Therefore calmly stroke over the fixed
piece of foil until you get a smooth result. Proceed as described with all pieces.
5. Once finished please check all edges for overlapping or lose edges. This will extend the longevi-
ty of the foil.

Husqvarna AUTOMOWER 430X Specifications

General

Product Name	Husqvarna AUTOMOWER 430X
Category	Lawn Mower
Cutting Width	24 cm
Cutting Height Min	20 mm
Cutting Height Max	60 mm
Battery Type	Li-ion
Typical Charging Time	50 min
Maximum Incline Within the Working Area	45 %
Cutting System	3 pivoting razor blades
GPS-assisted Navigation	Yes
Lift Sensor	Yes
Tilt Sensor	Yes
Ultrasonic Sensor	No
Battery Voltage	18 V
Weight	13.2 kg
Connectivity	Bluetooth, Cellular
Weather Resistance	Yes
Warranty	2 years