Note: For some models, a factory PIN code
is necessary before you select a personal
PIN code. It is not possible to use 0000 as
PIN code.
4. Push the Start button and close the hatch to
initiate a calibration process of the product.
Note: If the battery is too low, the product
needs to charge the batteries fully before the
calibration starts. Refer to
Calibration on
page 25
.
Note: Make a note of the PIN code. Refer to
Introduction on page 3
.
3.9.3 Calibration
The calibration process is automatic. After the
basic settings are done, the product moves away
from the charging station and stops, while it
calibrates some of the product settings. When the
calibration is complete, the product starts to mow.
3.10 Automower
®
Connect app
The product can connect to mobile devices that
have the Automower
®
Connect app installed. The
app uses long-range cellular connectivity.
Automower
®
Connect is a free app for your
mobile device. The Automower
®
Connect app
gives extended functions to your Husqvarna
product. You can:
• See the status of your product.
• Change settings to your product.
• Get extended product information.
• Get an alarm if the product moves out of the
work area.
To pair the product with the app, refer to
To pair
Automower
®
Connect and the product on page
35
.
Note:
All countries do not support Automower
®
Connect because of regional specified cellular
systems. The included Automower
®
Connect
lifetime service only applies if there is a third part
sub-supplier of 2G/3G/4G available in the
operational area.
3.10.1 To install the Automower
®
Connect
app
1. Download the Automower
®
Connect app on
your mobile device.
2. Sign up for a Husqvarna account in the
Automower
®
Connect app.
3. An e-mail is sent to the registered e-mail
address. Follow the instructions in the e-mail
in less than 24 hours to validate your
account.
4. Log in to your Husqvarna account in the
Automower
®
Connect app.
3.10.2 Automower
®
Connect menu
The main menu in Automower
®
Connect offers 4
options:
•
Dashboard
•
Map
•
Settings
3.10.3 Dashboard
The dashboard shows the current status of the
product both visually and in text. It is very easy to
control the product by selecting the options, for
example
Park
.
In the lower part of the dashboard there are
shortcuts to the
Schedule settings
and the
Map
.
The dashboard also shows symbols according to
below:
1. The battery status shows the battery state of
charge. A flash is shown over the battery
symbol when the product charges its
battery. A plug is shown over the battery
symbol when the product is in the charging
station without charging.
2. Cutting height.
1230 - 002 - 30.03.2020
Installation - 25
To Next Page
Loading...
