Husqvarna AUTOMOWER 440 - Schedule

2. Cutting height.
For more information about the operating modes
Start, Park and Pause , refer to Operating mode
Start on page 39
.
3.10.3.1 Map
The map shows the current position of the
product and the set centerpoint for GeoFence.
3.10.3.2 Settings in Automower
®
Connect
The product has factory settings but
the settings can be adapted to each
work area.
Most of the settings in the Automower
®
Connect app can be set in the display
of the product. Refer to
Display on
page 10 .
3.10.3.3 Messages
In this menu the previous fault and information
messages can be found. For some of the
messages, there are tips and advice to help to
rectify the fault.
Note:
The
Messages menu is only available for
Bluetooth
®
short-range connectivity.
3.11 To do the product settings
All commands and settings for the product are
done via the control panel. The control panel
consists of a display and a keypad, and all
functions are accessed through the menus. The
functions have factory settings to suit most work
areas, but the settings can be adapted to the
unique situation for each work area.
3.12 To get access to the menu
1. Push the STOP button.
2. Use the number buttons and the OK button
to enter the PIN code.
3. Push the MENU button.
3.12.1 Menu structure
The main menu contains:
• Schedule
• Cutting height
• Security
• Messages
• Weather timer
• Installation
• Settings
• Accessories
Refer to Menu structure overview 1 on page 7 ,
Menu structure overview 2 on page 8 and Menu
structure overview 3 on page 9 .
3.12.2 Schedule
Note: The lawn should not be cut too often to
obtain the best result. If the product is allowed to
operate too much, the lawn may appear
flattened. The product is also subjected to
unnecessary wear.
3.12.2.1 To set the schedule
1. Do steps 1–3 in To get access to the menu
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Schedule
> Overview
.
3. Use the arrow buttons and the OK button to
select the day.
4. Use the right arrow button to select the
period.
5. Push the OK button.
6. Calculate the suitable operating hours. Refer
to
To calculate the suitable operating hours
on page 27 .
26
- Installation
1201 - 004 - 25.03.2020