8. Remove the 3 bolts and the 3 spring washers.
Remove the power unit from the chassis.
9. Install the power unit in the opposite sequence.
6.9.2 To remove the cover from the power unit
1. Remove the power unit from the chassis. Refer to
To remove the power unit from the chassis on page
23
.
2. Turn the power unit with its top down on a piece of
cloth to prevent damages to the cover.
3. Remove the 8 screws that keep the cover attached
to the baseplate.
4. Turn the power unit with its top up and open the
battery hatch.
5. Remove the 6 screws.
1292 - 001 - Repair instructions - 25
To Next Page
Loading...
