6. Remove the cover from the power unit.
6.9.3 To remove the motor control box
1. Refer to
To remove the power unit from the chassis
on page 23
and
To remove the cover from the power
unit on page 25
.
2. Pull up the battery box cable and control panel cable
and disconnect them.
3. Loosen the screw and push the plastic plate to the
side.
4. Pull up the transmission cable and disconnect it.
5. Loosen the screw and push the plastic plate to the
side.
26 - Repair instructions 1292 - 001 -
To Next Page
Loading...
