6. Pull up the cables (A, B and C) and disconnect
them.
7. Remove the motor control box (D). Replace the
motor control box, if it is necessary.
6.9.4 To remove the battery control box
1. Refer to
To remove the power unit from the chassis
on page 23
and
To remove the cover from the power
unit on page 25
.
2. Loosen the screw and push the plastic plate to the
side.
3. Pull out the connections (A) between the battery box
and the motor and disconnect them.
4. Pull up the fan cables and disconnect them.
5. Remove the screws and remove the battery control
box.
1292 - 001 - Repair instructions - 27
To Next Page
Loading...
