English – 17
ASSEMBLING AND ADJUSTMENTS
Dismantling the cab
1 Dismantle the doors. For more information, see
“Dismantling the doors'.
2 Open the engine cover. For more information, see
'Removing the ride-on mower covers'.
3 Disconnect the electricity between the cab and the battery
by unplugging the contact between the cab and the
battery.
4 Dismantle the side cover. For more information, see
'Removing the ride-on mower covers'.
5 Dismantle the protective cover by unscrewing the 4
screws.
6 Loosen the cable harness from its attachment on the fuse
box.
7 Unplug the connection.
8 There is a loose rubber grommet in the fuse box. Fit the
rubber grommet into the empty slot.
9 Uncouple the heater hoses.
10 Remove the screw and washer from both sides behind the
seat.
11 Remove the screw and washer behind the heater hoses.
12 Remove the screw and washer at the driver’s door.
13 Fold forward the seat.
14 Attachments for the front work lighting also act as the cab
lifting points.
!
WARNING! ROPS must be fitted if the
machine is used without cab.
CAUTION! Coolant may leak from the hoses when
uncoupled. Place a rag under the hoses to prevent the fluid
from running out into the cab.
19mm
17mm
17mm
To Next Page
Loading...
