Husqvarna P 520D With cabin - Parking Brake Adjustment; Replacing Light Bulbs

32 – English
MAINTENANCE AND SERVICE
Adjusting the parking brake
Make sure the parking brake is properly adjusted by placing
the machine on a slope.
Apply and lock the parking brake.
When the machine does not stand still, the parking brake
should be adjusted according to the following.
1 Position the machine on flat ground.
2 Make sure the parking brake is released.
3 Adjust so there is 1 mm play between the outer cable and
the adjuster screw when you pull the outer cable.
Adjust the adjuster screw using the nuts.
4 Tighten the nuts carefully to prevent damaging the
adjuster screw.
5 The parking brake should be checked again after the
adjustment has been made.
Replacing the light bulbs
For information about the bulb type, see Technical Data.
Low beam, parking lights, turning lights
Unscrew the 4 screws holding the lamp insert.
Low beam
• Loosen the cables from the lamp.
• Loosen the lamp by holding down the spring lock.
• Insert the new lamp.
• Refit the cables and lamp insert.
Parking lights
• Loosen the cables from the lamp.
• Lift out the bulbs from the insert.
• Insert the new lamp.
• Refit the cables and lamp insert.
Turning lights
• Loosen the cables from the lamp.
• Loosen the lamp from the lamp insert by turning the lamp
counterclockwise.
• Insert the new lamp.
• Refit the cables and lamp insert.
!
WARNING! A poorly adjusted parking brake
can result in reduced braking ability.