44 – English
Lubrication
Lubrication schedule
SAE 10W 50 API SM = 8L
ANTIFREEZE =
50% Propylene Glycol
TIRE
PRESSURE = Front & Rear 1,5 bar
Front & Rear
TRANSMISSION OIL 10W 50 API SM SAE 80W/90 = 80cl (3oz)
0,9L
MOTOR OIL SAE 10W 40 API CP
3,0L
3,3L
QUICK MAINTENANCE GUIDE
First service after 25 hours
X-Variants
Legend for the lubrication schedule
Filter replacement
Oil change
Level check
Grease nipple
Oil can
Check belts, condition and belt tension
Belt replacement
General
Remove the ignition key to prevent unintentional movements
during lubrication.
When lubricating with an oilcan, it ought to be filled with engine
oil.
When lubricating with grease, unless otherwise stated, grease
503 98 96-01 or another chassis or ball bearing grease offering
good corrosion protection shall be used.
If the machine is used daily it should be lubricated twice a week.
Wipe away excess grease after lubrication.
It is important to avoid getting lubricant on the belts or the drive
surfaces on the belt pulleys. Should this happen, attempt to
clean them with spirits. If the belt continues to slip after cleaning
with spirits, it must be replaced.
Petrol or other petroleum products must not be used to clean
belts.
To Next Page
Loading...
