To engage and disengage the Roll
Over Protection Structure (ROPS)
• Remove the 2 pins that hold the ROPS and fold it
rearwards to disengage. Engage the ROPS in the
opposite sequence.
WARNING: Obey the following
instructions for the ROPS and the safety
belt.
• Do not use the safety belt if the ROPS is
disengaged.
• Always use the safety belt when the ROPS is
engaged.
• Make sure that the ROPS is correctly attached and
not damaged.
Operation
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To fill fuel
WARNING: Diesel is very flammable. Be
careful and refuel outdoors (see
Fuel safety
on page 11
).
WARNING: Do not use the fuel tank as a
support area.
CAUTION: Incorrect type of fuel can result
in engine damage.
• To meet the emission regulations, the fuel need to
meet the standard EN590 or ASTM D975 and have
a Sulphur content of less than 500ppm or 0,05% of
weight. Please refer to the Kubota Operators Manual
for further information regarding fuel quality.
• Use diesel with a minimum cetane rating of 45. Do
not use diesel that have a RME mix that contains
more than 5% in mineral oil-based fuels.
Note: If you operate the product in a temperature
below 0°C (+32°F). Speak to your Husqvarna
740 - 004 - 17
To Next Page
Loading...
