6. Turn the ignition key to the OFF position (A).
To apply and release the parking
brake
1. To apply the parking brake, move the parking brake
lever fully forward.
2. To release the parking brake, move the parking
brake lever fully rearward.
To set the power outlet to on or off
• Press the power switch (A) on the right control panel
to set the power outlet (B) to on or off. The voltage of
the power outlet is 12 V. The power outlet has a
fuse, see
Fuse overview on page 5
.
To get a good cutting result
• For best performance, do maintenance on the
product regularly as given in the maintenance
schedule. Refer to
Maintenance schedule on page
24
.
• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (highest
permitted engine speed, see
Technical data on page
44
). Move the product forward at low speed. If the
grass is not too high and thick, you can get a good
cutting result also at a higher speed.
• Cut the grass in an irregular pattern.
• To get the best cutting result, cut the grass
frequently and use the BioClip function.
740 - 004 - 23
To Next Page
Loading...
