Husqvarna P 520D - Lighting Component Replacement Procedures; Replacing Front and Rear Working Lights; Replacing Taillights

3. Turn the lamp counterclockwise and remove the
lamp.
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 44 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.
To replace the front working lights
1. Disconnect the cables from the broken lamp.
2. Turn the lamp counterclockwise and remove the
lamp.
3. Put the new lamp into the lamp housing. Refer to
Technical data on page 44 .
4. Connect the cables to the new lamp.
To replace the rear working lights
1. Disconnect the cables from the broken lamp.
2. Remove the screw on the connector.
3. Remove the lamp connector with the lamp attached.
4. Attach the new lamp connector. Refer to
Technical
data on page 44 .
5. Connect the cables to the new lamp.
To replace the taillights
1. Disconnect the cables from the broken lamp.
2. Remove the 2 screws on the connector.
3. Remove the lamp connector with the lamp attached.
4. Attach the new lamp connector. Refer to
Technical
data on page 44 .
5. Connect the cables to the new lamp.
740 - 004 -
29