• Empty the fuel tank. Start the engine and run it until
there is no remaining fuel in the carburetor.
Note: Do not empty the fuel tank and carburetor if a
stabilizer is added.
• Remove the spark plugs and put about a tablespoon
of engine oil into each cylinder. Manually turn the
engine shaft to apply the oil and attach the spark
plugs.
• Lubricate all grease nipples, joints and axles.
• Keep the product in a clean and dry area and cover
it for more protection.
• A cover for protection of your product during storage
or transport is available at your dealer.
Storage of the cabin
WARNING: Move the cabin carefully. The
cabin is heavy and can cause serious
injuries. Make sure the cabin is stable during
storage.
• Repair paint damages to prevent corrosion.
• Examine the product for worn or damaged parts and
tighten loose screws and nuts.
• Keep the product in a clean and dry area and cover
it for more protection.
• Keep the product in a locked area away from
children and other not approved persons.
• Put the cabin on the cabin support during storage.
Refer to
Cabin support dimensions on page 49
.
Disposal
• Chemicals can be dangerous and must not be
discarded on the ground. Always discard used
chemicals at a service center or an applicable
disposal location.
• When the product is worn out, send it to the dealer
or to an applicable recycling location.
• Oil, oil filters, fuel and the battery can have negative
effects on the environment. Obey the local recycling
requirements and applicable regulations.
• Do not discard the battery as domestic waste.
• Send the battery to a Husqvarna service agent or
discard it at a disposal location for used batteries.
740 - 004 -
43
To Next Page
Loading...
