EasyManua.ls Logo

Husqvarna P 524 - Chronometer; Parking Brake; Cutting Deck; Lever for Hydraulic Lift of Attachments

Husqvarna P 524
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14 –
English
PRESENTATION
Chronometer
The chronometer shows how many hours the engine has
been running.
Any time when the engine is not running but the ignition is
switched on is not registered. The last digit shows tenths of an
hour (6 minutes).
Parking brake
The parking brake is activated as follows:
LPress down the parking brake pedal (1).
20 Press in the lock button (2) on the frame plate.
21 Release the parking brake pedal while keeping the button
pressed in.
The parking brake lock is automatically disengaged when the
brake pedal is pressed down again.
Cutting deck
P524 can be fitted with the Combi 112 and Combi 122 cutting
decks.
The Combi-unit, equipped with a CombiClip plug, finely chops
the cuttings to fertiliser. Without the CombiClip plug the unit
works in the same way as a rear ejection unit. The rear ejector
ejects the clippings behind the unit without finely chopping them.
Lever for hydraulic lift of attachments
The lifting lever is used to put the cutting deck in either the
transport or mowing position when hydraulic pressure is
available.
Lifting the cutting deck (transport position)
Pull the lever backwards to engage the transport position.
Lowering the unit (mowing position)
Move the lifting lever forwards to engage the cutting position.
The deck is then lowered.
In order to ensure that the hydraulic cylinder is in the outer
position, hold the lever in the forward position for one to two
seconds after the cutting deck has hit the ground.
2
1

Table of Contents

Other manuals for Husqvarna P 524

Related product manuals