English – 29
MAINTENANCE
Assembling the cutting deck
1 Place the machine on a flat surface and apply the parking
brake. Check that the lever for setting the cutting height is
in the lowest position, position 1.
2 Push the equipment frame down and place the catch
against the frame.
3 Place the belt and the cable in such a way to prevent them
from being crushed.
4 Slide in the cutting deck and put the guide plugs in the
grooves on the equipment frame, one on each side.
5 Slide in the cutting deck so that the interior plugs touch the
bottom of the equipment frame’s grooves.
6 Place the cutting deck belt around the cutting deck drive
pulley. Hook in the height adjustment cable.
7 Secure the springs on the adjuster pulley.
Fit the front cover.
Removing the cutting deck
1 Put the cutting deck in the service position and lift off the
cutting deck drive belt”, see “Placing in the service
position” on page 30.
2 Fold up the cutting deck lock.
3 Pull out the cutting deck.
!
WARNING!
Wear protective glasses when assembling
the cutting deck. The springs that tension
the belt can fly off and cause personal injury.
!
WARNING!
Observe caution to avoid trapping your
hand.
!
WARNING!
Wear protective glasses when dismantling
the cutting deck. The springs that tension
the belt can fly off and cause personal injury.
!
WARNING!
Observe caution to avoid trapping your
hand.
To Next Page
Loading...
