16 –
English
PRESENTATION
Lights and power outlet
Lights
The lights are switched on and off using the switch on the
control panel.
Power outlet
A seat heater or mobile phone charger are examples of
articles that can be connected to the power socket.
The voltage is 12 V.
The electrical outlet socket is fuse protected by its own fuse,
which is located below the control panel.
Bypass valves
The hydraulic pressure must be released in order for the
machine to be moved when the engine is shutoff.
The hydraulic pressure is opened and closed using a bypass
valve.
Should you attempt to drive the machine without hydraulic
pressure it will not move. The drive on the axle is disengaged
when one of the valves is open.
P 524 has 2 valves, one for the front axle and one for the rear
axle.
• Rear axle bypass valve
- The hydraulic pressure is released by opening the locking
nut (1) 1/4-1/2 turn counter clockwise and then opening the
bypass valve (2) two turns.
- The hydraulic pressure is shut down by closing the valve.
Close the valve nut (2) tightly before the locking nut (1) is
screwed in place.
• Front axle bypass valve
- The hydraulic pressure is released by opening the locking
nut (1) 1/4-1/2 turn counter clockwise and then opening the
bypass valve (2) two turns.
- The hydraulic pressure is shut down by closing the valve.
Close the valve nut (2) tightly before the locking nut (1) is
screwed in place.
IMPORTANT! Always run the machine with both valves
closed.
To Next Page
Loading...
