10.Hold up the guide bar tip and turn the knob
clockwise to tighten it.
• Examine the chain tension frequently
after you assemble a new saw chain
and until the saw chain has been run-in.
• Examine the chain tension regularly.
Correct chain tension results in good
cutting performance and a long life.
To reset the chain brake
If the clutch cover is removed accidentally
while the chain brake is locked, the chain
brake must be unlocked so the clutch cover
can be assembled without binding to the
clutch drum.
CAUTION: The chain brake spring
is under tension. Use care when
resetting the chain brake.
Note: Do not hold the brake band while
attempting to reset it.
1. Align the notches on the bar tool so that
they fit over the brake rotating link.
2. To reset the brake, rotate the link clockwise
until it stops. The front link will be in its
downward rotated position when the chain
brake is unlocked.
Operation
WARNING: Read and understand
the safety chapter before you
operate the product.
To use fuel
CAUTION: This product has a
two-cycle engine. Use a mixture of
gasoline and two-cycle engine oil.
Make sure to use the correct
quantity of oil in the mixture.
653 - 006 - 10.02.2020 15
To Next Page
Loading...
