Husqvarna P02138HV - To lubricate the cutting equipment; Saw chain filing and saw chain combinations; To do a check of the saw chain lubrication

6. Make sure that you can pull the saw chain
round freely by hand and that it does not
sag.
To lubricate the cutting equipment
Saw chain filing and saw chain combinations
Saw chain
Chain type Round file
size
Side plate an-
gle
Top plate an-
gle
File guide an-
gle
Depth gauge
setting
H30 3/16 in. / 4,8
mm
60° 30° 10° 0,025 in. /
0,65 mm
H37 5/32 in. / 4,0
mm
60° 30° 0° 0,025 in. /
0,65 mm
To do a check of the saw chain lubrication
Do a check of the chain saw lubrication each
time you refuel.
1. Start the product and let it run at 3/4 speed.
Point the nose of the guide bar at a light
color surface almost 20 cm (8 in) away.
2. After 1 minute of running, a line of oil
shows on the light surface.
3. If you cannot see the line of oil after 1
minute, clean the oil channel in the guide
bar. Clean the groove in the edge of the
guide bar. Make sure the guide bar nose
sprocket turns freely and that there are no
blockages in the lubrication hole. Clean
and lubricate the tip sprocket.
4. Start the product and let it run at 3/4 speed.
Point the nose of the bar at a light color
surface almost 20 cm (8 in) away.
5. After 1 minute of running, a line of oil
shows on the light surface.
6. If you cannot see the line of oil after 1
minute, speak to your approved dealer.
30 653 - 006 - 10.02.2020