To start a cold engine
1. Move the front hand guard forward to
engage the chain brake.
2. Pull the choke control out fully.
3. Push the air purge bulb 6 times.
4. Hold the body of the product on the ground
with your left hand.
5. Put your right foot through the rear handle.
6. Pull the starter rope handle slowly with your
right hand until you feel some resistance.
7. Pull the starter rope handle with force.
CAUTION: Do not pull the
starter rope until it stops. Do not
let go of the starter rope when it
is fully extended. Release the
starter rope slowly. If you do not
obey these instructions, it can
cause damage to the engine.
Note: Do not pull the throttle trigger when
you start the engine.
653 - 006 - 10.02.2020 17
To Next Page
Loading...
