11.Immediately pull the front hand guard
rearward in the direction of the front handle
to disengage the chain brake.
Note: The chain will move.
12.Wait 10-15 seconds.
13.Pull the throttle trigger lightly to set normal
idle.
14.Use the product.
To start the engine when the fuel is too hot
If the product does not start, the fuel can be
too hot.
Note: Always use new fuel and decrease the
operation time during warm weather.
1. Put the product in a cool area away from
open sunlight.
2. Let the product cool down for 20 minutes at
minimum.
3. Press the air purge bulb again and again
for 10-15 seconds.
4. Obey the procedure to start a cold engine.
Refer to
To start a cold engine on page 17
.
To stop the engine
• Push the stop switch to stop the engine.
Note: The stop switch automatically goes
back to its initial position.
To fell a tree
1. Remove dirt, stones, loose bark, nails,
staples and wire from the tree.
2. Make a notch 1/3 the diameter of the tree,
perpendicular to the direction of the fall.
3. Make the lower horizontal notch cut. This
will prevent either the saw chain or the
guide bar from being pinched when the
second notch is made.
653 - 006 - 10.02.2020
19
To Next Page
Loading...
