4. Put a jack assembly below the product to make it
stable when the link stay is removed. The illustration
shows where to put the supports.
5. Make a note of the position of the grease nipples of
the link stay to make it easier to attach the link stay.
6. Turn the steering wheel fully to the right to get easy
access to the link stay.
7. Loosen the control stay (A) at the front and attach it
with a cable tie to the transmission shaft.
8. Put a jack assembly below the rear axle to remove
pressure from the link stay.
9. Disassemble the belt cover and the link stay below
the engine.
10. Disassemble the rear end of the link stay.
11. Disassemble the seat. Refer to
To disassemble and
assemble the seat on page 24
.
12. Remove the protection plate below the seat.
13. Loosen the 3 screws (A) on the pump belt slide.
14. Loosen the locknut (B) on the adjustment screw (C).
15. Loosen the pump belt adjustment screw (C) to
release tension on the belt.
662 - 001 - 23.10.2018 Repair instructions - 29
To Next Page
Loading...
