7. Attach the blades.
9.8 Equipment frame
9.8.1 To disassemble the equipment frame
1. Remove the cutting deck. Refer to
To remove the
cutting deck on page 63
.
2. Push down the equipment frame. Lift the equipment
frame lock to vertical position.
3. Measure the adjustment screw positions. Make a
note of the values and use them as initial values
when you assemble the equipment frame.
4. Loosen the adjustment screws.
5. Remove the left footrest plate. Refer to
To remove
the covers on page 23
.
6. Remove the automatic belt tensioner stay.
7. Release the lift chain from the equipment frame.
8. Remove the protection cover on the equipment
frame.
9. Release the belt from the equipment frame.
10. Remove the rear joint screws on the equipment
frame to lower it.
11. Pull the equipment frame fully rearward to release
the left side of the equipment frame.
12. Release spring tension fully.
13. Release the springs.
662 - 001 - 23.10.2018 Repair instructions - 69
To Next Page
Loading...
