Husqvarna P524 EFI - 9.10 Belts

7. Remove the cover (B) above the steering servo
housing.
8. Remove the 4 screws that hold the power steering
servo (A).
9. Put a container below the steering servo to collect
the spill oil.
10. Clean the hydraulic couplings. Obey the instructions
given in
To keep the hydraulic system clean on page
44 .
11. Disconnect the hydraulic hoses from the power
steering servo (A). Attach protective plugs.
12. Attach the new power steering servo in opposite
sequence.
13. Start the engine and turn the steering wheel to full
lock. Do a check for oil leakage.
14. Do a check of the oil level of the hydraulic oil tank.
Refer to
To do a check of the oil level in the
hydraulic system on page 46 .
9.10 Belts
9.10.1 To replace the drive belt for the cutting
deck
1. Lower the cutting deck.
2. Remove the front cover.
3. Pull the spring handle to the left out from the spring
holder to loosen the tension on the tension wheel for
the drive belt.
4. Remove the left side cover on the cutting deck.
5. Pull the spring stay from the lift chain.
6. Remove the 4 screws and remove the belt guard.
7. Remove the belt from the pulley, lift the belt holder
(A) and remove the belt from the tension wheel.
A
8. Remove the belt from the pulley on the tool frame.
9. Remove the belt guard below the engine pulley.
72 - Repair instructions 662 - 001 - 23.10.2018