Husqvarna P524 EFI - Page 55

21. Put a jack assembly below the product. The
illustration shows where to put the supports.
22. Tilt the hydraulic pump and remove it from below.
Note: If you replace the hydraulic pump, move the
hydraulic adapters to the new hydraulic pump.
23. Assemble in opposite sequence.
24. Tighten the hydraulic couplings. Adapter (A) torque
60 Nm. Adapter (B) torque 50 Nm.
A
A
A B
25. Adjust the hydrostatic transmission cable to get the
correct speed. Refer to To adjust the hydrostatic
transmission cable on page 52 .
9.5.16.2 To replace the hydraulic pump belt
1. Do step 1 - 11 in To disassemble and assemble the
seat on page 24 .
2. Remove the pulley guard.
3. Disconnect the electrical connector of the PTO
clutch.
4. Remove the 2 screws and the torque stop for the
PTO clutch.
5. Remove the front cover to get access to the PTO
belt.
6. Release the belt tensioner.
662 - 001 - 23.10.2018 Repair instructions - 55