English - 17
3
Secure a bolt in the vice, attain a distance of at least
18 mm and thread the clutch cover through the hole
where the bar bolt runs. Lock with the bar nut.
WARNING!
Exercise care to ensure the spring
does not fl y out and causes per-
sonal injury.
Wear protective goggles.
6.1 Dismantling the chain brake
2
Release the brake by pushing the kickback guard
forwards.
4
Loosen the screws and hold the cover in place with
one hand. Insert a screwdriver as illustrated over
the spring to prevent it from fl ying off when you lift
the cover.
Safety equipment
6 Safety equipment
1
Release the brake by moving the kickback guard
backwards.
Loosen the bar nut and remove the clutch cover,
chain and bar.
Fig 1
Fig 2
Fig 3
Fig 4
Fig 5
5
Carefully bend upwards until the spring is released
and slides over the screwdriver.
To Next Page
Loading...
