English - 21
Safety equipment
6.6 Dismantling the start/stop switch
1
Bend the start/stop switch loose with a screwdriver
(see fi gure 20).
2
Check that the start/stop switch is intact.
Cleaning and checking
Clean and check carefully all components. Parts
must be replaced if cracked or showing signs of
other defects. Always use original spare parts.
Fig 20
6.7 Assembling the start/stop switch
1
Attach the cables (se fi gure 21).
2
Push the start/stop switch into the slot.
Fig 21
Fig 22
Attach cable A, which comes from the ignition coil
on the upper plate on the stop switch (see fi gure
21 and 22).
The earth cable B, which is attached under screw
C (see fi gure 22 and 23), must be attached to the
lower plate.
Fig 23
To Next Page
Loading...
