Husqvarna T425 - Fuel safety

18 - English
6.2 Assembling the chain brake
1
Fit the weight L, spring M and the sleeve N
(see fi g. 8 and 9).
2
Fit the knee joint G and the fork H. Punch in the pin
F. Insert the pin J through the brake band K into
its slot. Place the fork H in the notch of the brake
band and place the brake band K in its track.
In the jointed end of G is a fi xed pin, which must be
placed in the notch in the fork H (see fi gure 9).
3
Fit the sleeve B and the screw A. Put the washer
D in place and tighten the nut E (see fi gure 6).
Put the spring C in place, use pliers to tighten the
spring behind the plastic peg (see fi gure 10).
Safety equipment
Fig 6
Fig 8
Fig 9
Fig 10
6
Loosen the nut E, washer D, spring C, sleeve B
and screw A.
To remove the knee joint G and H, use a punch to
press out the pin F. Pull out the pin J to loosen the
brake band K and knee joint H (see fi gure 7).
Cleaning and checking
• Clean and check carefully, all components.
Parts must be replaced if cracked or show-
ing signs of other defects. Always use original
spare parts.
• Measure the thickness of the chain brake
band. It mustn’t be less than 0.6 mm in any
place (see fi gure 9).
• Lubricate the knee joint with grease.
Fig 7
7
If necessary dismantle the weight L and check the
spring M and sleeve N.