English - 19
Safety equipment
Fig 11
4
Insert the screwdriver into the end of the spring
and press the spring together while pushing it
down with the fi nger.
5
Hold the spring in place with the fi nger and remove
the screwdriver. Insert the screwdriver straight
from above and press down until the spring catch-
es against the cut-out edge.
Fig 12
6
Bend the screwdriver away from the spring so that
the spring is pressed together and slips down to
the bottom.
Fig 13
7
Fit and tighten the cover.
Fig 14
8
Clamp the brake by moving the handle backwards
(see fi gure 15).
Fig 15
To Next Page
Loading...
