Husqvarna T425 - Dismantling the Intake System

English - 43
Repair instructions
7.14 Dismantling the intake system
Dismantle the:
• clutch cover
• air fi lter cover
• air fi lter
• air fi lter
holder
• handle lock
• carburettor
1
Bend loose the plastic covers C with a small
screwdriver and loosen screws B (see fi gure 51).
Unscrew screws 2xA and remove the cover.
Cleaning and checking
Clean and check all parts carefully. Parts must
be replaced if cracked or showing signs of other
defects. Always use original spare parts.
2
Press the inlet bellows D together and thread it
through the handle, which is now loose.
3
Remove the yellow cover paper E. Loosen the
screws and lift off the inlet bellows D.
Fig 52
Fig 53
Fig 51