PREPARING FOR USE 7
23
» If humidity, corrosion, or damage is found:
–
Clean and dry the connector, or change it if necessary.
Difficult operating conditions are:
– Rides on dry sand. ( p. 23)
– Rides on wet sand. ( p. 24)
– Rides on wet and muddy circuits. ( p. 26)
– Rides at high temperatures or slow riding. ( p. 26)
– Riding at low temperatures and in snow. ( p. 27)
7.4 Preparing vehicle for rides on dry sand
M01129-01
– Check the radiator cap.
Value on the radiator cap 1.8 bar (26 psi)
» If the indicated value does not correspond to the setpoint
value:
Warning
Danger of scalding During motorcycle
operation, the coolant gets very hot and is
under pressure.
– Do not open the radiator, the radiator
hoses or other cooling system compo-
nents if the engine or the cooling system
are at operating temperature.
– Allow the cooling system and the engine
to cool down before you open the radiator,
the radiator hoses or other components of
the cooling system.
– In the event of scalding, rinse the area
affected immediately with lukewarm water.
– Change the radiator cap.
M01272-01
– Mount the air filter dust cover.
Air filter dust cover (79006920000)
Info
Observe the fitting instructions for Husqvarna Motor-
cycles accessories.
To Next Page
Loading...
Need help?
General
