HUSTLER Super 104 - Page 32

REV B 6-2 117364
5. Lower the center deck to rest against the stop pin.
6. Set the deck cutting height for the front and rear side
deck gauge wheels at 3-1/4” (82.6 mm). Figure 6-7
7. Place a 3” (76.2 mm) high deck support block (two
stacked 2” x 4” blocks can be used to create a 3” [76.2
mm] high support) at the outside edge of the side deck.
Figure 6-3 & Figure 6-8
8. Lower the side decks to fully rest on the 3” (76.2 mm)
blocks.
9. Loosen the two 1/2” bolts on the rear gauge wheel arm.
Loosen the jam nut and adjusting bolt so the rear gauge
wheel is not supporting any of the weight of the side
deck. Figure 6-9
10. The front gauge wheel should contact the ground. If so,
skip to Step 11. If not, the gauge wheel will need adjusted
down per Step 12.
Figure 6-3
3” Block
3” Block
3” Block
3” Block
3” Block
3” Block
A – Measure to top of deck here
A
A
A
A
Figure 6-4
WARNING
Stop engine. Make sure deck clutch switch is in the down
(OFF) position. Place control levers in the brake position
before leaving machine.
3” Block
3” Block
Side view
Locator
triangle
Figure 6-5
1/2” Break-over bar
1/2” Extension
Square hole