117364 6-3 REV B
11. There should be less than .125” (3.18 mm) gap between
the 3” deck block and the bottom side of the deck edge.
Figure 6-8
If so, go to Step 13. If not, the gauge wheel will need
adjusted up per Step 12.
12. Adjust the front gauge wheel up or down to satisfy your
deck adjustment needs.
Adjustments are made by removing the front wheel from
the wheel tube and re-arranging the two .125” (3.18 mm)
and one .25” (6.35 mm)spacers located above and below
the front wheel pivot tube. Figure 6-10
Once Steps 11 & 12 have been satisfied proceed to Step
13.
13. Adjust the rear gauge wheel height. Tighten the
adjustment bolt on the bottom of the rear gauge wheel
fork assembly until the deck just begins to lift away from
the 3” (76.2 mm) block. Figure 6-9
14. Tighten the jam nut. Figure 6-9
15. Tighten the two 1/2” rear wheel arm bolts. Figure 6-9
16. Repeat for the other side deck.
17. When done, lift the side decks and remove the 3” (76.2
mm) blocks.
Figure 6-6
Figure 6-7
Figure 6-8
Set deck cutting
height at 3-1/4”
Figure 6-9
1/2” bolts
Jam nut
Adjusting
bolt
Rear wheel
arm
To Next Page
Loading...
Need help?
General
