HuTools HT01 - Notes Before Installation; Reset the Factory Setting

A. Notes Before Installation
Please kindly check the package list: Interior Assembly (F) and Battery Cover (G) has already
combined together. Please remove the battery cover before installation.
1. The Thumb Turn-piece must be vertical and the deadbolt latch needs to be in the
unlocked position when installing.
2. Verify that the deadbolt latch is in the proper position and check that the screws
securing the latch bolt are not over-tightened.
3. Reset the lock is required after installation. (Reset the lock to learn the orientation of
the door.)
4. Make sure the bolt hole on the door frame is at least 1 inch deep so the bolt fully
extends.
5. Check that the door closes properly so that when the deadbolt is extended, it is going
into the bolt hole and not hitting the deadbolt strike or door frame.
6. Please use 4 fresh AA standard alkaline batteries, Rechargeable or Extended Life
batteries shouldn't be used with the lock.
7. Make sure the cable is properly connected, and make sure the batteries are installed
correctly.
B. Reset the Factory Setting
(Teach the lock to learn the orientation of the door)
Note: make sure the door is OPEN. The Thumb Turn-piece must be vertical and the
deadbolt latch needs to be in the unlocked position.
① Insert 3 batteries in the lock, NOT insert the 4th battery;