- Disconnect ‘PD Bar Board’ cable from ‘Main Board’.
- Remove cap [19]
- Remove 4 screws on back side of [16].
(reference 3.3.1 PD-Bar Sub-Assembly)
- Then, remove 1 screw on back side of [16] from the [1].
Then, separate it. (Be careful contact with [18])
- Please see the drawing for disassemble, as needed
- Be careful to prevent from interfering with the [18]
which is included in the optical components
when assembling or disassembling the PD assembly.
- Assembly is the reverse procedure of disassembly.
To Next Page
Loading...
