Need help?Do you have a question about the Huvitz HLM-7000P and is the answer not in the manual?
General| Maximum Pupillary Distance (PD) Measurement | 85mm |
|---|---|
| Measurement Accuracy (Axis) | ±1° |
| Type | Automatic Lensmeter |
| Measurement Range (Cylinder) | 0 to ±10.00D |
| Axis Range | 0° to 180° |
| Add Power Range | 0 ~ +10D |
| Data Output | RS-232C |
| Power Supply | AC 100-240V, 50/60Hz |
| Vertex Distance | 0mm |
| Lens Diameter | Up to 100mm |
| Printer Type | Built-in thermal printer |
Lists the main components of the Auto Lensmeter HLM-7000P.
Outlines the step-by-step process for troubleshooting and repairing the Auto Lensmeter.
Provides essential safety warnings and precautions for using the instrument.
Explains how to check the software version displayed on the lensmeter screen.
Details the components and function of the lensmeter's optical system.
Explains the fundamental working principle of the lensmeter for measuring lenses.
Describes the procedure to enter and navigate the 'Setup Mode' for calibration.
Details the steps for calibrating the origin point of the lens measurement.
Guides on setting up the lensmeter using a standard lens set for accurate measurements.
Explains the procedure for calibrating the prism measurement function with standard lenses.
Details the process for calibrating the cylindrical axis using a +5D rectangular lens.
Describes the calibration procedure for the PD (Pupillary Distance) sensor.
Guides on calibrating the UV measurement capabilities of the lensmeter.
Lists the various diopter setting variables and their corresponding data.
Provides step-by-step instructions for replacing the CCD camera.
Details the procedure for replacing the LED assembly unit.
Outlines the steps for replacing the pinhole housing.
Details the process of disassembling the lensmeter's outer covers.
Illustrates the frame components and their assembly.
Details the components and assembly of the main structural backbone.
Details the components and assembly of the LCD screen unit.
Outlines the components and assembly of the UV bone unit.
Details the components and assembly of the front cover of the lensmeter.
Presents the overall electrical schematic and connections of the lensmeter.
Provides checks and troubleshooting steps for the SMPS (Switch Mode Power Supply).
Outlines the procedure for testing the LCD screen functionality.
Describes how to test the LED indicators and their functionality.
Details the testing procedure for the UV measurement module.
Explains how to test the PD (Pupillary Distance) measurement function.
Guides on testing the functionality of the built-in thermal printer.
Introduces the process and requirements for upgrading the lensmeter's firmware.
Step-by-step guide on using DNW application to update the lensmeter firmware.
To Next Page
