Hycontrol REFLEX - Pr.11 Relay 2 Designation; Pr.14 Relay 3 Designation; Pr.17 Relay 4 Designation; Pr.20 Relay 5 Designation

Ref: REFLEX/SCANFLEX MANUAL
EDITION 1: JULY ’97 24
Pr.11 Relay 2 Designation Common to all points.
Options are the same as Pr.8
Pr.12 Relay 2 Set Defined for each point
Options are the same as Pr.9
Pr.13 Relay 2 Reset Defined for each point
Options are the same as Pr.9
Note: Pr.14 - Pr.19 In multipoint systems a second Relay Module SR-10
would be required if more than 2 relays are required
per point.
Pr.14 Relay 3 Designation Common to all points.
Options are the same as Pr.8
Pr.15 Relay 3 Set Defined for each point
Options are the same as Pr.9
Pr.16 Relay 3 Reset Defined for each point
Options are the same as Pr.9
Pr.17 Relay 4 Designation Common to all points.
Options are the same as Pr.8
Pr.18 Relay 4 Set Defined for each point
Options are the same as Pr.9
Pr.19 Relay 4 Reset Defined for each point
Options are the same as Pr.9
Pr.20 Relay 5 Designation Programmable only on single point instruments.
Options are the same as Pr.8
Pr.21 Relay 5 Set Programmable only on single point instruments.
Options are the same as Pr.9
Pr.22 Relay 5 Reset Programmable only on single point instruments.
Options are the same as Pr.9